dc2-2-ap1

I am getting rid of a variety of items I purchased but decided not to use.
Located in Jacksonville, FL

ap2 bumper and cr lip sold
I got this from a fellow member a couple months ago but decided not to use it. I would rather get new brakes. There is a little damage to the bumper. The side tabs have slight damage but does not affect mounting. There are two small cracks on the bottom of the bumper but are not visible when the lip is installed. I don't think they would be visible if an oem ap2 lip was used instead of the cr lip. The holes for the cr lip have not been drilled.





BNIB H&R 15mm spacers (rears) These come with a set of extended studs (replace factory studs)
60 picked up / 70 shipped



Custom cut 10mm Fahrzeug Technik spacers for the rear
50 picked up / 60 shipped


ARP extended wheel studs (10) 30 shipped


ARP exhaust manifold studs (8) 30 shipped
These are new but I bought them without the nuts- hence why they are in a bag instead of a package.


J's racing engine torque damper mount 25 shipped

TRD_Celica

Deciding weather or not I should drive 7 hours for the bumper lol :/

RonnieB

If you decide to separate and ship, I'll take the lip. Just saying.

dc2-2-ap1

You should. I could meet you in savannah to save you a lot of time.

TRD_Celica

Savannah,GA? I live in biloxi, ms

pkolaboy

I'll take the exhaust manifold studs, would they work with turbo manifolds?

dc2-2-ap1

I responded on my phone so it didn't say your location and I confused you with redcelica who lives in nc.

dc2-2-ap1

They work with some but not all. They were fine for my old revhard manifold but too short (for my liking) on my inline pro log manifold.

TRD_Celica

I pmed you my number

dc2-2-ap1

cr lip and bumper sold