AP1 Flywheel
I did leave some toeplay at the top of the pedal so that's not the issue, and I replaced the clutch line with a stainless line and bled it a number of times to make sure there's no air in the system. The pedal feels firm and comes back smoothly and doesn't hang. I will double check tomorrow though.
Thanks for the advice guys!
Thanks for the advice guys!
Oh and another reason your lucky is cause i'll only have access to that flywheel machine for 2 more weeks.... last day is the 25th. Start at www.cncenginedynamics.com on the 28th 
So I increased the toe play some more and it didn't slip this morning at all. I will give it some more time and see if it doesn't again. I already bought an OEM clutch off Amazon since it was $300 so worse comes to worse I have a new clutch just sitting hehe.
Thanks again for all the advice.
Thanks again for all the advice.
Thread
Thread Starter
Forum
Replies
Last Post










