Rollbar install

Reply Subscribe

Thread Tools

Apr 30, 2010 | 08:15 PM

#81

metros

Joined: Sep 2008

Posts: 2,104

Likes: 4

From: NoVA

I would at least foam in the pit below where the bolts will be. Then that won't be getting moisture, rocks, etc. inside while you wait to retighten.

Apr 30, 2010 | 08:23 PM

#82

leadfootgirl

Thread Starter

Joined: Apr 2009

Posts: 12,740

Likes: 1

From: md

ahh ok. did you get the foam at home depot?

I just checked.. i have drill bits up to 3/8 and the hole is 3/8.. so i think we're good.

Edit: Slows2k did post this on a previous page so

i'm a moron sometime.

Apr 30, 2010 | 08:46 PM

#83

Olegator

Joined: Dec 2007

Posts: 3,641

Likes: 1

From: Gaithersburg, MD

I got some foam...

May 1, 2010 | 05:00 AM

#84

metros

Joined: Sep 2008

Posts: 2,104

Likes: 4

From: NoVA

On my way. See you guys in a few.

May 1, 2010 | 05:06 AM

#85

DanZilla

Joined: Mar 2008

Posts: 28,633

Likes: 1

From: Fort Bragg, NC

on my way in 15 minutes

May 1, 2010 | 06:45 AM

#86

Slows2k

Former Moderator

Joined: Sep 2002

Posts: 45,374

Likes: 429

From: Mother F'in TN

This thread needs pics

May 1, 2010 | 08:15 AM

#87

FF2Skip

Registered User

Joined: Aug 2002

Posts: 48,203

Likes: 10

From: Lewisville, TX

Good luck.

May 1, 2010 | 09:06 AM

#88

leadfootgirl

Thread Starter

Joined: Apr 2009

Posts: 12,740

Likes: 1

From: md

Everything us cut and drilled.. Going for the final fitting now...

May 1, 2010 | 11:29 AM

#89

speed_bump

Registered User

Joined: Mar 2002

Posts: 24,687

Likes: 195

From: MoCo

Bar was in when I stopped by. Ali was cranking a socket wrench tightening the last of it down when I got there and shooting foam in the wheel wells when I left.