EMS series 1 and o2 sensor issue
Thread Starter
Registered User
Joined: Jun 2015
Posts: 35
Likes: 0
EMS series 1 and o2 sensor issue
Hi,
I'm hoping someone has seen this issue before and can offer a solution. I have an AEM 30-4110 connected to an AEM series 1 however the value is not changing in AEM pro. My positive is connected to a switched 12v, ground to the chassis and signal (white) to pin C16. The gauge responds fine and I have good voltage at the signal wire. The EMS just doesn't seem to recognize it. I did the o2 wizard and chose "AEM gauge", set the gain and did the calibration table. Am I missing something?
Thanks
I'm hoping someone has seen this issue before and can offer a solution. I have an AEM 30-4110 connected to an AEM series 1 however the value is not changing in AEM pro. My positive is connected to a switched 12v, ground to the chassis and signal (white) to pin C16. The gauge responds fine and I have good voltage at the signal wire. The EMS just doesn't seem to recognize it. I did the o2 wizard and chose "AEM gauge", set the gain and did the calibration table. Am I missing something?
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
spapdx
S2000 Forced Induction
11
Oct 16, 2020 09:48 AM