Hello, forum. I'm here to get everyone's insight on what I should do regarding getting parts for my rebuild. I already have a head that is machined with AP2 springs, retainers,valves(the whole 9 yards). The story is my exhaust valve on cylinder 3 bent and chewed up my head and piston head along with the walls of the sleeve. It's currently getting the old sleeves punched out and getting steel sleeves put in with 4 brand new piston heads. She already had an oil leak prior to this happening so I was wondering what gaskets I should get since the whole motor is getting rebuilt. I've also have been sitting on ARP headstuds that I've had for a while, but have heard mixed feelings about them(the engine is stock top to bottom). Thank you so much.

 

would ask the machinist doing the decking for advice as CR will vary