The temperature here has been fluctuating the past few days (45-70) and I can't seem to dial in a consistent pressure all the time. I will post my logs and calibration when I get home, but the wastegate duty trim error adjust doesn't seem to adjust enough. On a cold day I will hit ~14psi, and on a warm day maybe 12.

Here are my settings (off the top of my head)
Boost cut : 15psi
Negative (minimum) adjust : 8%
Positive (maximum) adjust : 8%
Feedback int: 0
Feedback pro: 0
Freq : 32kHz

I am not using the boost target comp. table. Instead I have duty cycles mapped out on the main wastegate table. I also don't fully understand what the pro/int feedback does exactly.

I'd appreciate any insight, thanks.