Hey guys, just a little something i threw together. Car is moving and couldnt be happier! Heres the setup on the car:
Stock EVERYTHING!
2.0 Motor
AP2 Retainers
Inline Pro Headgasket
Precision Turbo
Revhard Manifold
2,940Ibs with driver
Pump gas 93 461rwhp 286tq @19Ibs tuned by Fernando Cunha

Building the rear now since the diff finally gave out after 30-40 hard passes. Upping the boost another pound or two,mixing in some race gas, and heading for 10s. My mission is mid 9s as a full street car.

Big thanks to the following people:
Fernando Cunha @CLM Motorsports
All the guys @ Inline Pro
Bryan Orjuela @B.Orjuela Photography
Tootsi @Tristate Motorsports in Perth Amboy,NJ
Tai @ IAMTAIBOOGIE
Tim @ERacerProductions

Follow my build on Instagram: j_gallego







DYNO SESSION: http://www.youtube.com/watch?v=u0M9MyK6GG4

SpringNationals: http://www.youtube.com/watch?v=MW8Y6ftsAQY

 

I watched this video Taiboogie made and was really impressed with the setup. Did you freshen the motor up or just left it untouched ?

 

thanks man. When i installed the headgasket at 77k (now 92k) I sent the head to Fischer Automotive in Edison NJ to get the retainers installed,get the head cleaned,and had the valve seals replaced. The bottom end is untouched.

 

Good stuff!

 

arp headstuds? havnt seen a 3mm build in a while, good luck on 9s, what turbo?

 

gl bro...im headed down to etown this friday if u wanna come by

 

thanks man

Stock Studs, precision 60-1 with .63 hotside. Small turbo but gets the job done


EDC is friday at Citi Field