How do you hook up the optional Greddy A/F harness
#1
Registered User
Thread Starter
Join Date: Jun 2008
Location: High Point NC
Posts: 1,894
Likes: 0
Received 0 Likes
on
0 Posts
How do you hook up the optional Greddy A/F harness
I have a Greddy turbo kit and AEM Uego and bought the optional A/F ratio harness so I could monitor the A/F ratios in the emanage. Does anyone know what wire goes where. I plugged the harness into "option 1" on the emanage and it has a blue and white wire coming out of it (I think those are the colors). The Uego also has a blue and white wire coming from one of its harnesses for monitoring purposes. I think I remember reading it wasn't simply color to color. Does anyone know how to hook these up? Thanks guys!
#4
No, the Blue wire is serial output wich would be hoked up using a 3.5mm jack to the serial port if you wanted t use that port.
No problem i asked this a while back and never got an answer and had to do some research on www.emanageforums.com to find it. The emanage is a big mystery and the people that understand it want to keep it that way.
No problem i asked this a while back and never got an answer and had to do some research on www.emanageforums.com to find it. The emanage is a big mystery and the people that understand it want to keep it that way.
#7
Registered User
Thread Starter
Join Date: Jun 2008
Location: High Point NC
Posts: 1,894
Likes: 0
Received 0 Likes
on
0 Posts
Thanks again ds, I got it hooked up last night. Was easy enough.
Joey, you still need to get a new bung welded in the downpipe for a wideband. I'm glad I did it before I even started my install. I wouldn't want to take it off after I installed it, but the wideband has been useful to me.
Joey, you still need to get a new bung welded in the downpipe for a wideband. I'm glad I did it before I even started my install. I wouldn't want to take it off after I installed it, but the wideband has been useful to me.
Trending Topics
#8
I have a emanage blue and uego. I hooked up white to white and grey to ground. What do I do in the parameter settings? I cant seem to get anything to save if I change the one drop down from "disconnect" to "a/f". Also I cant seem to expand the parameter screen more than this. I know there is vtec and other check boxes lower down on the screen that cant be seen.
#10
can some one tell me when i connect white to white and grey to same ground as aem car wont run??? theres only one white on the harness and theres two white on the gauge.. i used the white coming from the aem 02 sensor