yeah, thats pretty much what i've used from day one, specially when I street tune it.

From comparing it w/ a few dyno sessions to what they have if i remember, I think the difference was like less than .1

 

is a uego required for tunning on the dyno by the tuner?

 

The dyno should have a built in A/F sensor so, no, no need for a UEGO.


UEGO is just good for doing your own fine tuning.

 

Well I'm having an issue inputing the CAL data. According to the UEGO Gauge manual 10.0A/F = 0.0V and so on and so forth.

When I go to change the units in the O2 Sensor#1 CAL table, the highest number it will let me input is 9.38 A/F ratio??? Even when I do the auto wizard the A/F ranges from 4 to 8 at 5v??? What gives? My A/F units are set to A/F so I have no idea what these numbers are representing?

Any ideas? (I can post a screenshot if needed)

 

NM, I think I got it working, even though I had A/F units set it was still reading (I guess) lambda