Ok guys, i just got my 650 injectors and im considering a HG from http://www.directtuning.com/store/pc-60874...-C4335-030.aspx Is this what i need to run more than 12lbs of boost? Shouldnt it be 87mm for stock head? Can i use the 89mm with no problems? Should i have it tuned to be right at 12 so i dont need a HG? After tune ill be well over 400 but my redline will be back at 9G

 

ok so i just ordered the inlinepro 3mm HG and RC 650cc injectors with the clips. I hope this will run safely after tuning.

 

your going to run the 3mm HG with the vortech?

not feeling that

Unless you plan on having you v2 reworked to a t-trim, this will only handicap your numbers.

 

Please explain? If i want to go up in boost to say 14 with my 650 injectors then i thought i had to go to a 3mm.

 

anymore opinions on the 3mm HG with my setup?

 

why not just run 12 psi and make the same if not more power?

 

Reliability

 

i'd think it's the power that decreases reliability, not the pressure you're pushing into the cylinder. Granted, there's a direct link between the two though.

 

hey Jay-Z, what HG did you go with?
any update on your numbers?

 

Wow there's a lot of misinformation in this thread. Nice job.