Just finshed taping the Intake Manifold tonight and have the new AEM 3.5 Bar Map Sensor installed and now comes the wireing part....

The AEM MAP has 3 wires for it being the Black (ground)....Red (5v)....Green (signal)

simple enough??


The stock MAP has the 3 wires also.....so looking at it installed....the driver side wire is (Green w/red stripe).....the middle is (Green w/white stripe).......and the passenger side wire is (Yellow w/red stirpe)

I haven't spliced into anything yet and tested the voltage but i was wondering if anyone can help me out with what wire will connect to what??? If it matters this is an '04.

THANKS, BILL

 

green w/ red stripe is MAP signal, one is power and other is ground forgot which one is which

 

ok great.......i got 1/3 or my question answered .....anyone else know which of the other 2 go to where so i don't get them mixed up.....THANKS

 

aight the other two is yellow/red-positive voltage and the green/white is ground

 

THANKS Dsgs2k3

 

bc - got a picture of where you installed the AEM MAP?