AP2 with NOVI1000 Comptech SC.
So I have 7PSI 4" pulley. I also have 3.6" Pulley and supposedly that should make 10psi. Is that correct?


I am currently with 600cc RC injectors and I am looking to max them out, what would be the max boost I can run without swapping for larger ones?

Also what is the correct pulley sizing for AP2 with NOVI1000, I keep googling and searching s2ki with no solid answers. Well they are solid answers... just all different. LOL, but I think it's due to different blowers.

 

3.6" Pulley = 8psi on AP2

SOS pulley chart

 

^ Just doesn't sound right. I make 7psi with 4" right now.


You see what I am talking about here?

 

Who makes the pulleys you are using now?

 

Seem to be blank silver pieces. *Shrug* This 3.6" came with the kit and I was told it was 10PSI.

 

If you have good bolt on's (I/M/E/D) then it up's the boost a little too.

 

I do. my 4" I see 6psi even tho im told it's 7psi. (Stock pulley is 4.5" right? Which is 5.5psi)


4 to 3.6" bump and I should be at 8psi?

I am not following this pattern. So wait...


4.5" 5.5psi
4.0" 7psi
3.6" 8psi


????

 

So can anyone confirm that 3.2" pulley with 600cc injectors is 10psi and will work with stock MAP?

 

I know this is not much help, but I am running a 3" and id1000's, previously I ran the 3.6 and my 650's were did the job.

 

Could help if you can tell me me what boost each pulley got you and whether this was NOVi1000 or not

EDIT: Aaaah sh!t, you have an AP1. lol damn it