You could always de-pin the wires from the harness. I know what you mean with regard to an ever accumulating storage of "stock s2k parts." What was once a section of a drawer on my workbench is now a corner of the garage.

 

Ya that's what I was debating. That'd clean it up a bit further.

 

I just got around to install KPro. If this sensor is disabled is it ok to remove it and use the location as an oil feed line? I like working with this location rather than the traditional oil pressure sensor. Ease of access.

 

Yes. I'm using that location as the oil feed for my turbo. I'm using a 10x1.25--> -3AN banjo bolt (since my manifold sits so close):

 

The amount of clearance between my banjo oil feed and the FBM T4 sidewinder manifold:

 

What's what size socket to take off the oil pressure sensor? I just tried unbolting mine and snapped the plastic piece off...

 

i believe its a 21 mm???

 

Ok thanks. Tomorrow when I go pick up a new switch i'll pick up a deep socket.

 

its either 21 or 22mm

 

Thank you for the how to! Ill be doing this tonight