Official Enkei RPF1 Thread
Joined: Mar 2007
Posts: 5,997
Likes: 0
From: chino hills
Originally Posted by f20milo,Jun 3 2008, 02:02 PM
Damn...! You went to the extrem(on the rolling cutting etc..)! 
Im getting either these or the nt03's but im going with (front) 17x8 45 offset and (rear) 17x9 38 offset...
Im getting either these or the nt03's but im going with (front) 17x8 45 offset and (rear) 17x9 38 offset... +38 might work if you do everything i said + run 245 tire but 255 is pushing it. the reason i did that cutting/rolling/pulling is i would hate it if i went out to lunch with my friends or went to the movies with a girlfriend going over a bump and hearing that scrap sort of embarrassing plus i do not like high offset rims and i dont like finger gap so yea 
Registered User
Joined: Dec 2007
Posts: 1,242
Likes: 0
Originally Posted by superfly092886,Jun 3 2008, 02:33 PM
+38 might work if you do everything i said + run 245 tire but 255 is pushing it. the reason i did that cutting/rolling/pulling is i would hate it if i went out to lunch with my friends or went to the movies with a girlfriend going over a bump and hearing that scrap sort of embarrassing plus i do not like high offset rims and i dont like finger gap so yea
Registered User
Joined: Mar 2003
Posts: 1,834
Likes: 0
From: Los Angeles
Originally Posted by f20milo,Jun 3 2008, 03:02 PM
Damn...! You went to the extrem(on the rolling cutting etc..)! Im getting either these or the nt03's but im going with (front) 17x8 45 offset and (rear) 17x9 38 offset...
Im getting either these or the nt03's but im going with (front) 17x8 45 offset and (rear) 17x9 38 offset...roll/pull/cut/relocate bumper tab
17x8 & 17x9 +45 all around
(f)225/40/17
Registered User
Joined: Jan 2006
Posts: 768
Likes: 0
From: Im big in Japan...
Originally Posted by f20milo,Jun 4 2008, 08:45 AM
Question for you... 1)Why do you roll if you cut??? 2)Why so much work if its not that agressive?? 3) What & where is the bumper tab??