since i am stationed overseas in Lima,Peru i am unable to phsically do any measurments to the interior of my car. I have only seen one S2000 here and i have no idea whose it is or where it went.

would anyone be willing to take some measurements for me???

i am about 5'7" so i would like someone to measure with the seat placed in the middle setting on the seat rails and reclined about halfway or whatever is average reclined spirited driving position.

with this setting please measure the floor space from the back of the seat to the rear wall then measure about a one foot up the rear wall and from there measure the space between the rear wall and seat.

the idea behind these measurements is for specs to build a speaker box behind either passenger seat and/or driver seat to run a JL 6Wv3 in either a sealed box or ported. maybe even potentially run a sealed 8W3v3 or any 8 if possible.

if everything works out i will do a write up on my build for those who would like some extra bump in the cabin.

i dont want to run any subs in the trunk or footwell either.

any help would be greatly appreciated

 

Im 6'1" and there is zero room behind me


Sent from your sisters phone using Tapatalk

 

not going to happen

 

Kinda late to this, sorry for the bump, but I was thinking, if it were to happen, it would have to take advantage of every nook and cranny back there. You could possibly take a trash bag, and some expand-a-foam, put the bag in behind the seat, and shoot the foam into it. Make sure you don't put too much in, that foam would ruin the interior. Let it setup and dry, and now you have somewhat of a mold to fiberglass with.

I have done this for other projects, to get a starting mold to work with, But if you go to crazy with the foam, you will ruin the interior.

I am 5'10" tall, and I have the seat pretty much all the way back (the back is 2 clicks back from the stock setting and then the seat is pushed to the farthest click back before the seat touches the back panels) I have so little room back there.

If you have the money, check out this: https://www.s2ki.com/s2000/topic/841...-installation/
I just got one with the Memphis sub. I haven't installed it yet though. It's sitting in my living room staring at me. The price is up there, but the quality is good, and I did some simple math and decided having my DD down for at least a week trying to build the mold and cost of materials would end up being the same as just buying it.