888

Hello everyone,

I am new to this forums and very excited to be here! sorry if I am bringing up some old topics and questions...

So this is my first effort to start my journey in aftermarket parts.

I just bought an amuse R1 bumper from an authorized seller. I was told that they won't come with a license plate holes and to my surprise it came with a very well prepared and threaded license plate mounting holes, well that took care of the cosmetic issue and not drilling the unnecessary holes...

Unlike the most of the photos online, the inner side is black and not white. So far so good...

Now I know before the paint job I have to do a fit test to make sure everything will line up well.

I noticed that the amuse doesn't have the holes for the existing 9 original bolts on the bottom that keep the bumper attached. My question is "Do I have to drill those holes after fit test OR amuse requires less screws to install ? Please share your knowledge and experience.

Thank you so much.

NNY S2k

I think you'd have better luck getting an answer if you post in this forum:
https://www.s2ki.com/s2000/forum/193...ons-and-parts/

Levi

888

Thank you Levi, I am new and having a little problem to navigate the site. I did my best to look up different topics but no success so far. Thank you for your kind reply.

NNY S2k

No problem, I hope you get an answer..... welcome to the site.
Levi

888

Thanks for warm welcoming and replying to my post.

Cheers.