Sorry guys and gals bringing back an old thread.

Already have the ap2 bumper on just curious about the fender liners. The ap1 fender liners don't line up with the ap2 bumper as far as the screws and clips at the bumper.

Just wondering if the ap2 fender liners would line up on the ap1 locations in the fender well and etc?

 

Not perfect but you can use it

 

Been looking might just drill the holes in the ap1 fender liners and do it that way where the ap2 bumper would bolt up. It's been bugging me, just like it to be right......sorry.

 

The fender liner comes in pieces I believe, just buy the wheel well pieces and call it a day. $70 or so from majestic

 

The stock one is all one piece. Might get pricey that route. I just try drilling holes to line up with the ap2 bumper. Thanks for the help guys!

 

Trust me the stock one is not one piece. Tabs hold 4 sections together underneath the car.
Here's a reference http://www.hondaautomotiveparts.com/...=FRONT+FENDERS

 

My stock one piece ap1 fender liner.



All I'm talking about is the fender liners on each side. Not worried about any of the other plastic underneath the car.

 

My stock one piece ap1 fender liner.



All I'm talking about is the fender liners on each side. Not worried about any of the other plastic underneath the car.
[/quote]
That's what you need to replace with 04-up fender liner. The AP1 fender kinder isn't big enough to reach all corners of the front bumper

 

You can re-use your AP1 fender liner and use zip straps on 2 of the 3 holes where they don't reach the AP2 bumper.

If you want it done right, switch to AP2 fender liner.

 

this is an ap2 on an ap1
nothing was done to it or shaved off it was a direct bolt on