Has anyone made a 3D printed (or whatever) plate to screw in place over the opening where the cruise control controls are?

Not talking about the one on the dashboard, but the Resume/Set/Cancel switch on the right side that's held on by two screws. Looks like it'd be a simple piece but I don't want to reinvent the wheel if someone's already made one. I was going to ask a buddy with a 3D printer to make one up for me.

 

This must be your lucky day

I've got a European plastic rear panel, which mounts to the rear of the steering wheel. The cruise control panel is not punched out of it. It's a direct fit to our wheels and would be perfect for what you are looking for.

If you want it let me know and I can send it to you. Shoot me a pm. I guess they didn't have cruise control in the country where it originated from ? This is a rare part, I would just need a few bucks to cover shipping if you are interested.

 

Zeroptzero,

I know this is an old post, but I was curious if you still have the delete plate that you mentioned in the above post?

 

Curious if you still have the delete plate?

 

roel03 could make you one.

baero.tech is his website.

 

i made one out of abs plastic, just a flat sheet.