i have the NRG sitting in my garage. never installed it cuz of having to remove the tab. never got the motivation to do that.

 

Puddymod bracket

 

i used puddymod.
it was real PITA to install but the end result is good.

 

If i fudge this up or fail the puddy bracket will be going on lol

 

Sorry for the delay everyone, I almost decided not to go through with this but i had a change of heart. I modeled up the bracket, made a cardboard test piece (Never fails me) made a few more adjustments on the flat pattern and gave it to our laser operator to have it cut. Then off to the brake. Im hoping it will be lasered out today which might give me enough time to bug one of the brake press operators enough to get it bent up and finished today as well.

Stay tuned.

 

Well i just went out into the shop to disposition a job and saw this on the brake table...



I will install it tonight and take more pictures...

 

Sorry for the delays. Getting that strut bar on was a bitccccc. Some people had said bcause of raising the one side 3/16 (because of the bracket) it would touch the inner part of the hood. It might touch the insulation but i can still drop shut without issue. As far as performance goes my second gear is a little easier to shift into it just feels slightly smoother. Here you go!

 

Hey guys!
Sorry for my ignorance... But what is the real purpose of the etd?

 

looking good!!!

 

http://www.google.com/#hl=en&cp=22&g...w=1463&bih=619