DIY Rear Brake Ducts using B-Strakes
#1
Thread Starter
DIY Rear Brake Ducts using B-Strakes
This is a 2" rear brake duct using a modified OEM B-Strake and a 45° silicone elbow to support the duct beneath the rear, lower A-arm.
Here's what they look like:
Here's what they look like:
Last edited by hecash; 12-13-2016 at 09:06 PM.
#3
Looks good!
Questions about the set up:
- What is the B-strake? Not sure what part that is and where did you buy it?
- How is the 45° silicone elbow supported?
I want to keep this in mind when I get more comfortable with the S on the track.
Questions about the set up:
- What is the B-strake? Not sure what part that is and where did you buy it?
- How is the 45° silicone elbow supported?
I want to keep this in mind when I get more comfortable with the S on the track.
#5
Thread Starter
You can download my write-up on the project from the link on the S2000 Talk & Tech group on Facebook located here
https://www.facebook.com/groups/3832...3414772080640/
https://www.facebook.com/groups/3832...3414772080640/
#6
You can download my write-up on the project from the link on the S2000 Talk & Tech group on Facebook located here
https://www.facebook.com/groups/3832...3414772080640/
https://www.facebook.com/groups/3832...3414772080640/
#7
Registered User
This is going to get a lot more air (bigger scoop + larger hose) to the rear rotors and it doesn't hang any lower than the stock pieces which can be stored away unmolested.
Last edited by shind3; 12-21-2016 at 06:16 AM.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post