EZ Lip Splitter
02-01-2012, 09:07 PM
#21
i dont get why everyone is so negative about this mod. it looks pretty clean, almost like a CR front lip that has the bottom flat plastic part. ive been looking for a way to finish up my amuse front, it was always missing something to me. i was never brave enough to cut it up to make a proper splitter and adding a flat splitter on the bottom doesnt look right. this might be the perfect solution. thanks OP, just placed an order.
02-01-2012, 10:06 PM
#22
Former Sponsor
Join Date: Jun 2002
Location: Laguna Niguel
Posts: 5,267
Likes: 0
Received 0 Likes
on
0 Posts
Is this any different than the garage piece that home depot sells? Because the material will start to sag and deform over time.....not to mention it will flap around at pretty much any speed.
02-02-2012, 04:22 AM
#23
Registered User
Pretty sure it's the same kind of stuff. I hope for the price they're charging it's at least the nicest garage door sealer you can buy.
02-25-2012, 08:49 AM
#28
Registered User
Here's a pic of the "EZ splitter" installed on my car...
From this moment on I will be calling it a lip protector because that is what it is.
Sadly, I had it on for about an hour. The front became too low because the lip protector angles downwards towards the front at a pretty aggressive angle (45+ degree slope). Rubbed on every incline I encountered within the drive. So I pulled it off. It's a decent product but just not for me.
From this moment on I will be calling it a lip protector because that is what it is.
Sadly, I had it on for about an hour. The front became too low because the lip protector angles downwards towards the front at a pretty aggressive angle (45+ degree slope). Rubbed on every incline I encountered within the drive. So I pulled it off. It's a decent product but just not for me.
