to much effort has gone into this project lol... i would have cut it wrong and thrown my ipod against the wall.... nice job looks good :)

If you look around the top of your cut in the pictures, it looks like the left side is cut lightly stubbier then the right. Sort of like an unsymmetrical cut. I'm not sure how to describe it but where you cut it to make it round near the top. I was thinking you can get a rubber grommet or something to go around as a nice touch was what I meant secondly.

http://i17.photobucket.com/albums/b87/spyd...S2ITouch-27.jpg

that picture shows it particularly well. If you look near the top of where you cut, it looks as though it goes straight down on one side and not the other; it goes in slightly towards the bottom.

Effffinnn cleeeeeannnn..

How do you disconnect the cable? Normally the plug has 2 small buttons on the side that has to be pressed to release it.

BWAHAHAHHAHAHAHA.

x2.

that woudl be two broken ipods and two f'd up center console covers if we tried.

props for the sweet idea and dellivery. for me though, mine just sits in the side pocket in the passenger side of the car by the tranny hump. boom, took me 10 seconds :)

like yours, my HU controls it so i could care less where it is.

Great work which deserves its own place at the front page. :thumbup:

DIY Molding the iTouch into the Cup Holder Lid

I do see what your walking about now, Hmm thats strange... Im looking at it now, I think my camera is playing tricks, I cant see it in person... thats strange.

I forgot to mention that, I simply tore those hooks out with a pair of needle nose pliers.

Thanks Energetic! PRINTSCRN!

looks very good will there be one for a AP1 Version?

very nice. i like this a lot. came out looking sweet.