anyone on here remember how long it took to install them. including motors and wiring everything up. what about without the edfc

thanks

 

I just did mine about 2 weeks ago, tein circuit masters with dual edfc's, took 1 and a half days, but the work is top notch.

 

If your prepared when they arrive, with car on jack stands, wheels off, I dont think it took me more than 2-3 hours tops. Thats just the coilovers, I dont have the edfc.

 

How was the work top notch? What did you do different? Either you have them on right or you dont.

 

-- i had it done at a shop, as i lowered the car and adjusted camber, along with alignment to do ti all correctly - about 6 hours shop time iuncluding the alignment - teins with edfc

 

yea my dampening is already set up. i just heard that wiring it all up and removing the panels in the back are a pita

 

Its probably not to bad really, after wiring in an amp I learned all the secrets.

Behind the passenger seat panel theres actually a pass through you could use, then run them up either side, or up the middle. I dont think it would be to bad. Might take an hour or two extra.

 

I mean since there are two motors on each coilover, there was a few cables to pass through and under the dash, so it took a while to do it neatly. I am a bit of a perfectionist, thats all.

 

how do you like your dual edfc? i also have the circuit masters but am contremplating whether to spend my money on the dual edfc's or something else..

 

I havent played much with them yet, but i like them since you can adjust exactly to how you like them. On the softest setting they are still a bit too hard for the roads i drive on, but the handling part makes up for it anyway.