Car idles at 1500 rpms when fully warmed!! - S2KI Honda S2000 Forums

Go Back  S2KI Honda S2000 Forums > Special Interest > S2000 Naturally Aspirated Forum
Reload this Page >

Car idles at 1500 rpms when fully warmed!!

Notices
S2000 Naturally Aspirated Forum Discussions about N/A motor projects, builds and technology.

Car idles at 1500 rpms when fully warmed!!

Old 11-16-2018, 07:09 PM
  #1  
Registered User
Thread Starter
 
Join Date: Nov 2018
Posts: 5
Thanks: 0
Thanked 0 Times in 0 Posts
Default Car idles at 1500 rpms when fully warmed!!

Just bought a s2k but notice it’s idling higher than usual. It sits at 1500 rpms. Any causes or problems I should look after.
04s2000ATX is offline  
Old 11-16-2018, 09:45 PM
  #2  
 
Zer0ne's Avatar
 
Join Date: Jun 2006
Location: LA, California
Posts: 462
Thanked 6 Times in 6 Posts
Default

Try the idle relearn procedure.

Pull "backup" fuse under dash for ~10 minutes. Put back in, start the car with all accessories powered off. Let engine warm up to temperature and let the radiator fan cycle 2-3 times.
Zer0ne is online now  
Old 11-17-2018, 04:33 AM
  #3  
Registered User
Thread Starter
 
Join Date: Nov 2018
Posts: 5
Thanks: 0
Thanked 0 Times in 0 Posts
Default

I’ve done it a couple of times already and doesn’t seem to help, maybe I’ll try cleaning out the iacv today and see what happens.
04s2000ATX is offline  
Old 11-17-2018, 05:59 AM
  #4  
 
Chuck S's Avatar
 
Join Date: Jul 2014
Location: Chesterfield VA
Posts: 6,531
Thanked 194 Times in 189 Posts
Default

Proper amount of slack in the throttle cable?

-- Chuck
Chuck S is offline  
Old 11-18-2018, 11:24 AM
  #5  
Registered User
Thread Starter
 
Join Date: Nov 2018
Posts: 5
Thanks: 0
Thanked 0 Times in 0 Posts
Default

Throttle cable is good. No cel light whatsoever. So when I drive and come to a complete stop the rpms slowly but stay around 1300 rpms. I did try cleaning the iacv with some brake cleaner but nothing has changed.
04s2000ATX is offline  
Old 11-18-2018, 01:18 PM
  #6  
 
noodels's Avatar
 
Join Date: Nov 2013
Location: Norfolk
Posts: 3,187
Thanked 45 Times in 44 Posts
Default

Cleaned TB plate?
noodels is offline  
Old 11-29-2018, 08:16 AM
  #7  
Registered User
 
sk2_bri's Avatar
 
Join Date: Jul 2018
Posts: 45
Thanked 3 Times in 3 Posts
Default

Originally Posted by 04s2000ATX View Post
Throttle cable is good. No cel light whatsoever. So when I drive and come to a complete stop the rpms slowly but stay around 1300 rpms. I did try cleaning the iacv with some brake cleaner but nothing has changed.
Were you able to fix this? If not, have you checked the voltage from the throttle position sensor? If the previous owner replaced it with an aftermarket TPS, it may not be adjusted correctly. IIRC it should be 0.5V at idle and 4.5V at WOT.
sk2_bri is offline  
Old 11-29-2018, 10:26 AM
  #8  
 
s2000ellier's Avatar
 
Join Date: Aug 2011
Location: Florida
Posts: 4,116
Thanked 56 Times in 45 Posts
Default

vacuum leak somewhere
s2000ellier is online now  
Old 11-29-2018, 01:32 PM
  #9  
 
S2kAndTheAnt's Avatar
 
Join Date: Feb 2007
Location: 703->781->626
Posts: 1,632
Thanked 4 Times in 4 Posts
Default

Originally Posted by s2000ellier View Post
vacuum leak somewhere
I agree.
S2kAndTheAnt is offline  
Old 11-30-2018, 12:00 PM
  #10  
Registered User
Thread Starter
 
Join Date: Nov 2018
Posts: 5
Thanks: 0
Thanked 0 Times in 0 Posts
Default

I’ve searched for leaks and haven’t found anything. I’m not sure how good skunk2 throttle body are, maybe that’s causing the revving. I’m clueless
04s2000ATX is offline  

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2018 MH Sub I, LLC dba Internet Brands