I just purchased standard works bell hub (model 223) and a personal neo grinta steering wheel (330mm). The problem I'm having mainly has to do with the horn button fitting in to the hub hole. The button plastic is ever so slightly bigger than the hole on the hub. My question is, do you have to trim the button plastic a little? I tried assembling the steering wheel setup together before actually installing it when I discovered the issue. Has anyone run into this issue?
Any helpful advice welcomed! Thanks in advance.

 

Same issue.

Had to sand down down the horn button slightly to get it to fit. No issues after that.

 

Hmm. I'll give that a try and see if that works. Thanks for the advice!