Ap1 vs Ap2 bumper
Registered User
Joined: Jun 2005
Posts: 1,946
Likes: 0
From: West Los Angeles
When you put the AP2 bumper on an AP1 you have to shave about 1/4 inch or so off the front support beam(both sides). If you don't you will notice little bubbles in the bumper around the headlight area. It happened to me. I shaved the beam and the bubbles went back down. There is a DIY thread somewhere.
PS use an angle grinder or you'll be sorry. it makes the process much easier.
PS use an angle grinder or you'll be sorry. it makes the process much easier.
Registered User
Joined: Nov 2006
Posts: 253
Likes: 0
Originally Posted by Blue_S2,Mar 7 2007, 05:20 PM
When you put the AP2 bumper on an AP1 you have to shave about 1/4 inch or so off the front support beam(both sides). If you don't you will notice little bubbles in the bumper around the headlight area. It happened to me. I shaved the beam and the bubbles went back down. There is a DIY thread somewhere.
PS use an angle grinder or you'll be sorry. it makes the process much easier.
PS use an angle grinder or you'll be sorry. it makes the process much easier.
Thread
Thread Starter
Forum
Replies
Last Post