I'm so back and forth on those voltex over fenders. Would it look dumb if my stance didn't match and I didn't change my wheels or tires? And do I have to destroy my original ones to install? Or is it just over ?

 

here is just with oem wheels and I have to say I was border liking them. But now with the wheels they look even better. I didn’t cut fenders, I rolled, lowered and run 255/40/17 without any problems

 

IMHO, those just look like more stick on body panels, lines don't flow, look at the ends of the wheel arch flares..they stop abruptly in the middle of the panels..

 

Trial fitting of the BasonR replica AP2 lip before painting. A little reshaping is needed..not terrible

..

 

I drove that bad boy from Sacramento to Donner Pass and back! Top down, streaming music, super light traffic and the streams/rivers in the Sierras were so full and beautiful I had to stop several times to take it in!
86 degrees in Sacramento but 61 at the summit. Perfect!

 

Reinforced those UCA brackets as a "while I'm in there" kinda thing during a coilover and spherical compliance bushing install.

I shouldn't have got myself into this.

 

Dropped the top

 

Took off the cover and pushed it outside so I could clean up the garage, tried to start it to drive it back in but the battery didn't have enough juice so ended up pushing it back in again.

Rolled the cover back on.

Pouted a little.

 

That's such a boring garage..way to clean to get anything done...

 

Hahaha! Sorry I didn't remove my COV-19 mask our of the background... ruined the pic!