When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
This past weekend I installed new Modifry elastic straps for my top and fitted some Cordura 'runners' to the inside of the top to prevent the usual wear to the top. Then I picked up my kid from gymnastics and drove her around for the first time with the top down. Initially she was reluctant to get in this car but after a few minutes of getting to ride 'shotgun' in the open air she threw her hands up in the air and yelled " I love this car". Made me proud.
Getting fresh tranny and diff fluid on Thursday. Almost time for my first weekend road trip...
This past weekend I installed new Modifry elastic straps for my top and fitted some Cordura 'runners' to the inside of the top to prevent the usual wear to the top. Then I picked up my kid from gymnastics and drove her around for the first time with the top down. Initially she was reluctant to get in this car but after a few minutes of getting to ride 'shotgun' in the open air she threw her hands up in the air and yelled " I love this car". Made me proud.
Getting fresh tranny and diff fluid on Thursday. Almost time for my first weekend road trip...
Go to post #105 on pg 11 and you will see a pretty good illustration of what it is. I went 4.5 inches wide by about 50 inches long. (Sorry not too sure what I trimmed it down to but it's not to critical if you starts a little long and trim to an appropriate length).
Ap1Drivers pics are posted first but I went with Jah's variation and I think it will work quite nicely. I already had the material so it only cost me about 20 minutes of my time.
About half-way through installing a Robbins top with the glass conversion on my AP1.
Almost as much fun as the clutch install I did last fall.
At least I didn't spend two hours trying to find the starter bolt.....
About half-way through installing a Robbins top with the glass conversion on my AP1.
Almost as much fun as the clutch install I did last fall.
At least I didn't spend two hours trying to find the starter bolt.....
stick with it. I did mine a couple weeks ago. it's a pain, but worth it in the end.
Was told the drivetrain fluids looked and felt pretty good but definitely feels better at the stick and sounds smoother in the rear end with freshy. Good to go..
Just installed The EVS Tuning 70-SSP exhaust on my S. Really Dig the Sound! almost no Drone.
Also Installed A JDP diffuser since i really didn't like the empty space on the driver side of the rear. was on the fence about it but i ended up really liking it.
What I did to my S today?
