Stack ST400 rev counter setup(number of cyl.)
05-05-2008, 01:22 AM
#1
Registered User
Thread Starter
Join Date: Mar 2008
Location: Poland
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
Stack ST400 rev counter setup(number of cyl.)
Could you tell me what type is the tacho output from ECU in s2000. I am willing to use Stack st400 rev counter that is setup now to 8 cylinder and i need tosend it back to Stack to reset it to whatever i need to run it with s2000 engine. It is one of the early units so cannot be set up by user with the push buttons.
The question is how i have to set it up. to 1 , 2 or 4 cylinder? This depends on the type of tacho output so i need to be sure how many ignition events per 1 revolution ofthe crankshaft is shown on tacho output from ECU.
Thanks for help.
Tomasz
The question is how i have to set it up. to 1 , 2 or 4 cylinder? This depends on the type of tacho output so i need to be sure how many ignition events per 1 revolution ofthe crankshaft is shown on tacho output from ECU.
Thanks for help.
Tomasz
Thread
Thread Starter
Forum
Replies
Last Post