Steering Torque Sensor AP2 Missing Alignment Letters
Thread Starter
Registered User
Joined: May 2020
Posts: 3
Likes: 0
Steering Torque Sensor AP2 Missing Alignment Letters
Picked up a brand new (hard to find anymore) Honda OEM in the box AP2 Steering Torque Sensor for a spare.
However I don't see the "AB Alphabet Stamping" on the shaft that is shown in the Torque Sensor Replacement procedure for alignment.
Is it possible that the stamping was only used/needed on the AP1 Torque Sensor?
However I don't see the "AB Alphabet Stamping" on the shaft that is shown in the Torque Sensor Replacement procedure for alignment.
Is it possible that the stamping was only used/needed on the AP1 Torque Sensor?
Joined: Jul 2013
Posts: 5,734
Likes: 632
Picked up a brand new (hard to find anymore) Honda OEM in the box AP2 Steering Torque Sensor for a spare.
However I don't see the "AB Alphabet Stamping" on the shaft that is shown in the Torque Sensor Replacement procedure for alignment.
Is it possible that the stamping was only used/needed on the AP1 Torque Sensor?
However I don't see the "AB Alphabet Stamping" on the shaft that is shown in the Torque Sensor Replacement procedure for alignment.
Is it possible that the stamping was only used/needed on the AP1 Torque Sensor?
Updated version has a revised torsion bar so it's not that critical.
Thread
Thread Starter
Forum
Replies
Last Post
Hyperdrive
S2000 Under The Hood
1
Jun 22, 2021 03:47 AM
wkeeling
S2000 Modifications and Parts
4
Oct 26, 2016 05:08 AM