just did a clutch change on my ap1, and i just got everything bolted back up and i went to shift with the car not running and it shifted fine, but when i crank it up it will bnot go into any gear and if i try to put it in say 3rd the rpms drop like the car is going to stall out. any ideas on where i could have messed up?

 

Slave cylinder is not functioning or release fork is not installed correctly are my guesses.

 

yea i started to mess with it last night but i was so worn out i gave up, ill look more into that later thanks

 

first thing that came to my mind as well

 

Those are about all it can be, call me and ill swing by and well get it figured out.