Hey everyone,

I've had a small leak out of my transmission rear case seal for quite some time now (see picture below). I finally got around to tearing it apart and now I'm stumped, everything I've read calls for hondabond but apparently there are many different kinds of Hondabond? I THINK I need to use Hondabond HT but I've seen Ultraflange mentioned a few times too. Can anyone confirm which sealant I should be using for this seal?

Thanks

 

Permatex Grey RTV.

 

I used Hondabond HT when I did mine. It's fine. I didn't go out to buy it as I had it laying on the shelf.

 

Thanks guys!

Hope to get this back together later this week