ANVIL weighted and countersunk stainless steel shift knobs! 1 LB+
#126
Former Sponsor
Thread Starter
I will most likely have a burnt titanium one before a burnt stainless one. Driving me nuts trying to get the right burn lol. Might just not be able to turn a dark enough color being so thick and all. That or I need higher heat. Been using MAP gas which is a good bit hotter than propane.
I want one so bad though lol. First one is going in my car!! Always wanted a burnt one but titanium is too light for my liking.
I want one so bad though lol. First one is going in my car!! Always wanted a burnt one but titanium is too light for my liking.
#129
Former Sponsor
Thread Starter
No luck with it yet. I think I am going to wait on other finishes for now. I can do custom powder coated finishes for an added cost of $10 a shift knob though.
Burning I will work on when I have some free time. The blackening process I just haven't had time recently to work on. I will at some point but won't be for a little while.
Thanks everyone for all the orders over the weekend! Shipping out Tuesday as I believe post office is closed tomorrow.
Burning I will work on when I have some free time. The blackening process I just haven't had time recently to work on. I will at some point but won't be for a little while.
Thanks everyone for all the orders over the weekend! Shipping out Tuesday as I believe post office is closed tomorrow.