punchdrunk

Hey

Any suggestions as to where I can get a centre section for a Greddy TI-C dual exit exhaust. Alternatively how easy is it (and cost) to fabricate one?

Thanks

Pelidan

You've seen this exhaust on ebay too then...

I think it's a case of getting an exhasut place to make the middle pipe to be honest.

That's what I was thinking of doing!

blue monster

I thought these were complete stainless steel systems - what do you reckon has happened to the centre section

punchdrunk

The exhaust on ebay is mine actually - I bought it like that. The previous seller advertised it as a complete exhaust. They offered a full refund, but I'll have to pay to send it back and hang around for couriers, so thought I'd list it and see what happens.

If I can get a pipe fabricated I might keep it. Any ideas where?

Thanks

Imarriedmys2k

Zorstec in shipley west yorkshire are exhaust wizards!!! Theyll do it

Pelidan

Imarriedmys2k - im hoping i see you around mate! Im looking to get an exhaust on my S, and ill prob get zorstec to do it as they are 5 mins away from my house!

punchdrunk - You would need an exhaust place to fabricate you a pipe, it wouldnt be difficult. Im not sure how much it would cost though.

blue monster

I've just bought one of these systems off this forum which is in fantastic condition however the gaskets look a bit sorry for themselves.

Am I best to get new Greddy gaskets from the US or can a place such as Zorstec or any decent exhaust dealer/fitter provide me with some that will do the job?