WTB Cam Position Sensor PLUGs (aka TDC plug)
12-27-2018, 03:08 PM
#1
Thread Starter
WTB Cam Position Sensor PLUGs (aka TDC plug)
The little tabs broke on mine, I need two (2) Cam Position Sensor Plugs. These are the two little plugs on the back of the cylinder cover of an AP2.
I believe an Evap Solenoid plug will work as well.
Honda doesn't sell these separate and you need the entire harness.
Thanks.
I believe an Evap Solenoid plug will work as well.
Honda doesn't sell these separate and you need the entire harness.
Thanks.
12-28-2018, 02:02 AM
#2
Sumitomo HX .040 - .090 Connector and Terminals
What you're looking for should be on this page. To be sure visually cross-reference yours to the pics on the site for the proper connector.
What you're looking for should be on this page. To be sure visually cross-reference yours to the pics on the site for the proper connector.
12-28-2018, 06:25 AM
#3
Thread Starter
I was seeing if anyone had them first, I ordered 4 yesterday as well from Cycle Terminal and wasn't sure how long it would take to get them.
The actual correct part is HX090-2, and confirmed by user @daeven . This is for AP1 and AP2 up to 2005. Cycle Terminal shipped them this morning. And their facebook page shows he's also a NSX owner and makes all kinds of stuff for them. Need to see what he can do for the S2ki community!
The actual correct part is HX090-2, and confirmed by user @daeven . This is for AP1 and AP2 up to 2005. Cycle Terminal shipped them this morning. And their facebook page shows he's also a NSX owner and makes all kinds of stuff for them. Need to see what he can do for the S2ki community!
Thread
Thread Starter
Forum
Replies
Last Post
