ITB Turbo Part 2
#1
Registered User
Thread Starter
Join Date: May 2002
Location: Washington State
Posts: 3,178
Likes: 0
Received 0 Likes
on
0 Posts
ITB Turbo Part 2
Well, the project is finally done except for the tuning. That takes place next Monday and Tuesday. I'll post the results and dyno numbers when that is done. Until then, here are some more pictures of the project along with a list of what was done - I'll start with that:
1. New shortblock and head built by Laskey Racing
2. Interior stripped and floorpan given 3 coats of QuietCar for sound insulation.
3. Custom roll bar welded in
4. New Kirkey aluminum seats
5. Aquamist HFS-5 direct port water/methanol injection system installed.
6. Defi gauges installed in dash.
7. Boost controller changed to Turbosmart eBoost2.
8. Most importantly, a new custom built ITB intake manifold with 4-50mm throttle bodies.
9. New twin carbon disk Carbonetic clutch/flywheel.
Here are some pictures of the finished product.
This is where I ended up mounting the AEM IAT sensor. A better location than on the plenum where it would get heat soaked.
Water injection pump and electronics
Finished out trunk with water/meth tank
ITB direct port injectors
New gauge locations
Completed engine with old heat shiels in place
Kirkey seats
1. New shortblock and head built by Laskey Racing
2. Interior stripped and floorpan given 3 coats of QuietCar for sound insulation.
3. Custom roll bar welded in
4. New Kirkey aluminum seats
5. Aquamist HFS-5 direct port water/methanol injection system installed.
6. Defi gauges installed in dash.
7. Boost controller changed to Turbosmart eBoost2.
8. Most importantly, a new custom built ITB intake manifold with 4-50mm throttle bodies.
9. New twin carbon disk Carbonetic clutch/flywheel.
Here are some pictures of the finished product.
This is where I ended up mounting the AEM IAT sensor. A better location than on the plenum where it would get heat soaked.
Water injection pump and electronics
Finished out trunk with water/meth tank
ITB direct port injectors
New gauge locations
Completed engine with old heat shiels in place
Kirkey seats
Trending Topics
#9
Great Setup.
Since i don't know your story from the beginning,what about the rear end?
I like the steering Wheel a lot.
I wanted to be the first to say WOOOW. but its too late now.
And can you share how much something like this would cost?
Cheers.
Since i don't know your story from the beginning,what about the rear end?
I like the steering Wheel a lot.
I wanted to be the first to say WOOOW. but its too late now.
And can you share how much something like this would cost?
Cheers.