Custom ETD Bracket
09-22-2011, 10:07 AM
#14
Registered User
Thread Starter
Join Date: Jul 2010
Location: Geneva, NY 14456
Posts: 1,023
Likes: 0
Received 0 Likes
on
0 Posts
10-07-2011, 03:26 AM
#15
Registered User
Thread Starter
Join Date: Jul 2010
Location: Geneva, NY 14456
Posts: 1,023
Likes: 0
Received 0 Likes
on
0 Posts
Sorry for the delay everyone, I almost decided not to go through with this but i had a change of heart. I modeled up the bracket, made a cardboard test piece (Never fails me) made a few more adjustments on the flat pattern and gave it to our laser operator to have it cut. Then off to the brake. Im hoping it will be lasered out today which might give me enough time to bug one of the brake press operators enough to get it bent up and finished today as well.
Stay tuned.
Stay tuned.
10-07-2011, 04:20 AM
#16
Registered User
Thread Starter
Join Date: Jul 2010
Location: Geneva, NY 14456
Posts: 1,023
Likes: 0
Received 0 Likes
on
0 Posts
Well i just went out into the shop to disposition a job and saw this on the brake table...
I will install it tonight and take more pictures...
I will install it tonight and take more pictures...
10-08-2011, 05:03 AM
#17
Registered User
Thread Starter
Join Date: Jul 2010
Location: Geneva, NY 14456
Posts: 1,023
Likes: 0
Received 0 Likes
on
0 Posts
Sorry for the delays. Getting that strut bar on was a bitccccc. Some people had said bcause of raising the one side 3/16 (because of the bracket) it would touch the inner part of the hood. It might touch the insulation but i can still drop shut without issue. As far as performance goes my second gear is a little easier to shift into it just feels slightly smoother. Here you go!
10-08-2011, 12:16 PM
#20
Registered User
Thread Starter
Join Date: Jul 2010
Location: Geneva, NY 14456
Posts: 1,023
Likes: 0
Received 0 Likes
on
0 Posts