Where to get Stainless welded...
#4
Looking at a custom exhaust using one of gernby's gernzhaust mid pipes. I would either be hacking up an existing exhaust system or using a couple of vibrant mufflers. Split after the Y to the mufflers needs to be equal length.
#5
Making the split after the y equal length is kinda hard but I guess it can be done. I made a single for a friend using the gern pipe. It seemed to do its job and not drone. What did you have in mind about making it equal length after the y? I would imagine the passenger side pipe would have to go to the driver's side and then turn back towards the passenger side again. Something like this I would think would take 6-8 hours of labor time.
#7
The invidia q300 is equal length after the Y as well as the T1R EM Sparrow.
Basically, I want it to look like the Greddy SE Exhaust but be equal length after the Y w/ a gernzhaust mid pipe.
Edit: Here is a pic of the Y piping for the invidia.
and T1R EM Sparrow
Basically, I want it to look like the Greddy SE Exhaust but be equal length after the Y w/ a gernzhaust mid pipe.
Edit: Here is a pic of the Y piping for the invidia.
and T1R EM Sparrow
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post