Cusco floor bar weight...
Registered User
Joined: Nov 2005
Posts: 5,749
Likes: 0
From: Orange County CA
Originally Posted by MINES13,Jan 16 2007, 06:29 PM
YO bling king, hit me up this week.
I will give you a call either later today or tomorrow. Blink king 
. You know everything but the ARC parts on my car are functional 
Registered User
Joined: Nov 2005
Posts: 5,749
Likes: 0
From: Orange County CA
The change in stiffness is noticable when you really drive the car, under normal driving conditions its minimal. If you just have the floor bar you may not notice as much of a difference, but when using an X or U-brace, floor bar, and tie bar I think the chasis has a lot less flex then before these parts were installed. I give it 
Note: My answer is from the use of the ASM bar your question was for the Cusco bar, because the designs are so similiar, my experience should apply to both products
Note: My answer is from the use of the ASM bar your question was for the Cusco bar, because the designs are so similiar, my experience should apply to both products
Thread Starter
Registered User
Joined: Nov 2002
Posts: 170
Likes: 1
From: IL
Originally Posted by neveronlines2k,Jan 18 2007, 02:06 PM
Note: My answer is from the use of the ASM bar your question was for the Cusco bar, because the designs are so similiar, my experience should apply to both products
are the cusco bars bolt-in and how noticable is the change in stiffness?
Thread
Thread Starter
Forum
Replies
Last Post