Spoon calipers?

Reply Subscribe

Thread Tools

Oct 8, 2008 | 07:45 AM

#11

Voodoo_S2K

Joined: Aug 2001

Posts: 17,792

Likes: 4

From: Bay Area, California

Quote:

Originally Posted by slightly2ned,Oct 7 2008, 05:49 PM

You can however bore our a rear 10mm spacer to fit the front, but this would ruin the integrity of the spacer IMO.

I see no problem with doing that. It seems weird that someone would sell a spacer with just a small bore size. My T1R 3mm spacer is more then big enough to fit over the front bore.

Oct 9, 2008 | 07:56 PM

#12

slightly2ned

Registered User

Joined: Sep 2007

Posts: 8,527

Likes: 1

From: Yee!

Quote:

Originally Posted by Voodoo_S2K,Oct 8 2008, 07:45 AM

I see no problem with doing that. It seems weird that someone would sell a spacer with just a small bore size. My T1R 3mm spacer is more then big enough to fit over the front bore.

Yeah, most of the spacers I found on the market are between 64-67mm bores. I had a very hard time finding a front hubcentric, but I did today. Sounds too good to be true, so lets see if this website ripped me off.

Its OK, I used a card so I can dispute it if it is any different from what was advertised to me.

Oct 10, 2008 | 11:01 AM

#13

fenixv8

Joined: Jul 2006

Posts: 1,136

Likes: 2

hey im running spoon calipers in front on ce28's with a 3mm spacer np. If i wanted to temporarily use the stock 17inch rim from my ap2, what size spacer would i need

Oct 10, 2008 | 11:52 AM

#14

WashabiS2K

Joined: Feb 2006

Posts: 9,563

Likes: 8

From: San Francisco, Bay Area

Quote:

Originally Posted by fenixv8,Oct 10 2008, 12:01 PM

hey im running spoon calipers in front on ce28's with a 3mm spacer np. If i wanted to temporarily use the stock 17inch rim from my ap2, what size spacer would i need

15mm or more. Last time I tried running a 15mm spacer with ap2 v1 rim, it scratched the finish off of my caliper (rotora, not spoon.. but both are about the same size IIRC)