ap2 taillight install help!
Joined: Jul 2007
Posts: 28,386
Likes: 107
From: Right Here.
Originally Posted by freezingcoffee,Sep 10 2009, 01:52 PM
I started today, my dremel saw bit broke after every 4 inch cut and then it eventually just burned the motor out. I'm just going to give in and buy a saw!
Joined: Nov 2001
Posts: 11,594
Likes: 7
From: Bumpass, VA
Originally Posted by HMFIC,Sep 10 2009, 03:13 PM
not at you. That is........
unless.......
You're not laughing
. And if that's the case then 
I suspect Allan _is_ laughing at you 
Good luck!
Registered User
Joined: Oct 2005
Posts: 10,158
Likes: 2
i just have to say I TOLD YOU SO lol.
listen to someone who has done the job--angle grinder is the best tool for the job. and i'll also say that you will waste so much time and money if you keep trying other tools that just won't work. after 2 minutes with the saw you will want to find a better tool trust me. and air body saw will work also but not nearly as good as the angle grinder, and you'll need a compressor for it.
listen to someone who has done the job--angle grinder is the best tool for the job. and i'll also say that you will waste so much time and money if you keep trying other tools that just won't work. after 2 minutes with the saw you will want to find a better tool trust me. and air body saw will work also but not nearly as good as the angle grinder, and you'll need a compressor for it.
Registered User
Joined: Jun 2007
Posts: 6,163
Likes: 0
From: 7 CITIES VA
Originally Posted by infinite_phases,Oct 20 2009, 05:46 PM
I did my tail lights with a dremel and it is taking forrrrrrrrrrrrrever. So long that I only got one side done and am driving around with one ap2 taillight and one ap1 taillight. LOL!
This is an S2000 Terry. 
That scenario is _not_ [LOL] funny! 
Thread
Thread Starter
Forum
Replies
Last Post