I stand corected, H/R DOES make a 20 and 25mm DRM Integral Spacer. See this chart for all the proper info:

Front:

5/114.3 70.1 Stud 12x1.5 DRS 5mm Front Axle 1065700 $ 68.95 Pair
DRS 10mm 18 Front Axle 2065700 $ 119.95 Pair
DRS 15mm Front Axle 3065700 $ 119.95 Pair
DRM 20mm 8 Front Axle 4065700 $ 149.95 Pair
DRM 25mm Front Axle 5065700 $ 149.95 Pair

Rear:

5/114.3 64.1 Stud 12x1.5 DRS 5mm Rear Axle 1065640 $ 68.95 Pair
DRS 10mm 18 Rear Axle 2065640 $ 119.95 Pair
DRS 15mm Rear Axle 3065640 $ 119.95 Pair
DRM 20mm 8 Rear Axle 4065640 $ 149.95 Pair
DRM 25mm Rear Axle 5065640 $ 149.95 Pair

 

what front tire specs you are running?

 

Thanks s4play and everyone else who provided such great information and examples! Because of you guys, I was able to do this a lot easier than I would have otherwise

Fronts are 20mm H&R spacers (came with hubcentric rings)
Rears are 25mm Ichiba spacers (came with hubcentric rings)

I am dropped on Megan Racing coils with barely less than a finger gap all around.

Alignment settings are -2.5 front and -2.9 rear.

I tried to run the least camber possible in the rear, Evasive said -2.9 will be very close and I *very rarely* rub - usually only on big dips on the highway. Coilover damper is set on 8 all around on a 32-way adjustable, 0 being stiffest.







Thanks again guys for the help!

 

Dropped on Tein Monoflexes @ slightly higher than Tein recommended settings (recommendations are way too low)

Front:
20mm H&R Spacers w/ Built in Studs
AP2V1 Fronts
225/45/17 Dunlop Z1 StarSpecs
-1.8 Camber
Rolled, flared a tiny bit.

Rear:
25mm H&R Spacers w/ Built in Studs
AP2V1 Rears
255/40/17 Dunlop Z1 StarSpecs
-2.2 Camber
Rolled, bumper wheel well edge shaved, bolt repositioned 4" back.

 

how hard is it to take out the stock studs. i got some ichiba wheel spacers with extended studs. This is for the rear side btw

 

use a dremel and grind out the holes for clearance... unless you're doing extreme off roading you should be just fine. that or cut the remaining threads off the studs...

 

updated pics of my car with the Buddy Club N+ installed.

 

^^^ Looking good!!

 

Is that the Greddy SE? Pics from rear.

 

Looks nice liquidtek... IMHO, I hate eyelids.