All in one go
11-24-2011, 02:33 PM
#1
Registered User
Thread Starter
Join Date: Mar 2009
Location: Eugene, oregon
Posts: 760
Likes: 0
Received 0 Likes
on
0 Posts
All in one go
Instead of flooding the random talk I'll just start this.
Took off front bumper
Pulled out the secondary air pump
Only cuz they make this part to delete the pump
Took off the intake manifold but to do so had to pull off the alt.
Oil blow by and carbon build up in the runners
Cleaned the runners out and noticed the casting marks on the sides
I used a I think a 2pm ball hone and a drill. Took bout 15 min a runner
As she sits until I get a few more gaskets then its goin back together
Took off front bumper
Pulled out the secondary air pump
Only cuz they make this part to delete the pump
Took off the intake manifold but to do so had to pull off the alt.
Oil blow by and carbon build up in the runners
Cleaned the runners out and noticed the casting marks on the sides
I used a I think a 2pm ball hone and a drill. Took bout 15 min a runner
As she sits until I get a few more gaskets then its goin back together
11-24-2011, 10:09 PM
#5
Registered User
11-26-2011, 01:19 AM
#6
Registered User
Thread Starter
Join Date: Mar 2009
Location: Eugene, oregon
Posts: 760
Likes: 0
Received 0 Likes
on
0 Posts
New hondata gasket
Blocked off a few ports these are coolant lines leading to the bleeder
Gasket installed
Almost back together
Took a break
My final photo for the day.
And back at it in the am!
Blocked off a few ports these are coolant lines leading to the bleeder
Gasket installed
Almost back together
Took a break
My final photo for the day.
And back at it in the am!
Trending Topics
11-26-2011, 01:28 PM
#9
Registered User
Thread Starter
Join Date: Mar 2009
Location: Eugene, oregon
Posts: 760
Likes: 0
Received 0 Likes
on
0 Posts
Started the car last night and realized I needed s block off plate on the back side on the intake man. So exhaust didn't shoot out of it lol
So I ran to my shop and made this one out of Alu.
Now to reassemble the from end and double check everything
So I ran to my shop and made this one out of Alu.
Now to reassemble the from end and double check everything
Thread
Thread Starter
Forum
Replies
Last Post