Roll bar install recommendations
#1
Roll bar install recommendations
Hi folks,
My s2000 is becoming more track focused so I'd like to invest in additional safety equipment. Since the factory roll hoops are too low for me, I'm considering getting the rock star garage roll bar. Any recommendations on a shop that can do a clean install? I'd like to keep most of the interior pieces.
Thanks,
-Michael
My s2000 is becoming more track focused so I'd like to invest in additional safety equipment. Since the factory roll hoops are too low for me, I'm considering getting the rock star garage roll bar. Any recommendations on a shop that can do a clean install? I'd like to keep most of the interior pieces.
Thanks,
-Michael
#2
Hi Michael,
I'm building a track car too and am about to install a HardDog bar I purchased second hand locally.
I would HIGHLY suggest you post WHERE you are IN YOUR POST so people near you might be able to respond. You are posting in a National if not international forum and you are making us work to hard. You listed your place of residence as the US and not even a state much less a city so among friends here, we have no clue how to respond to your request.
Stuart
I'm building a track car too and am about to install a HardDog bar I purchased second hand locally.
I would HIGHLY suggest you post WHERE you are IN YOUR POST so people near you might be able to respond. You are posting in a National if not international forum and you are making us work to hard. You listed your place of residence as the US and not even a state much less a city so among friends here, we have no clue how to respond to your request.
Stuart
#3
Thanks Stuart, I thought I added location in my profile. Anyhow, I'm in the Seattle area and I'm considering 425 Motorsports in Bellevue. Anyone have any experience with them?
#5
Registered User
I agree with Magna on this, 425 and Stage will do it and I will suggest you have them do it. I did the Hard Dog install on my s2000 with Spets but it was a pain to get it done and if I were to do it again I would look at those two shops. The amount of work to remove and cutting you have to do is enough to warrant someone else doing it.
Thread
Thread Starter
Forum
Replies
Last Post
gcxnirvana
California - Bay Area S2000 Owners
11
01-17-2015 05:34 PM
kleecker
S2000 Racing and Competition
20
05-15-2011 02:54 PM