Alarm blinking after ECU reset
Thread Starter
Joined: Aug 2008
Posts: 115
Likes: 0
From: Spain
Alarm blinking after ECU reset
I have just installed an Invidia test pipe, after installing it I done the ECU reset switching off the 7.5 fuse, once I connect the fuse again (after 10 seconds) alarms starts blinking in intervals of 30 sec (more or less)
No way to disconnect it, remote control lock/unlock doors as always but doesn't disconnect the alarm blinking.
I also remove the negative from the battery but when I connect it again, alarm blinking starts again...
I can start the car like always, but alarm still sounding even driving
ANY IDEA? Don't know what to do.
I have to said that this alarm is a bit strange because no warnings lights are turning on
No way to disconnect it, remote control lock/unlock doors as always but doesn't disconnect the alarm blinking.
I also remove the negative from the battery but when I connect it again, alarm blinking starts again...
I can start the car like always, but alarm still sounding even driving
ANY IDEA? Don't know what to do.
I have to said that this alarm is a bit strange because no warnings lights are turning on
Thread
Thread Starter
Forum
Replies
Last Post