Android Single Din w/o Cutting!
#261
#262
oh, from your photo i assumed you already trimmed the dash since it looked installed.
I also don't want to trim the dash... and it looks like a LOT of it would have to go.
So i went back to the drawing board last night. Made this bezel to fit a standard 7" LCD. Just a test piece so far, need to see how it looks in the car.
There's also a bunch of wire bundles right under it, i'm not sure of those would hit also at this point. Oh, and that SRS module is also very close.
I also don't want to trim the dash... and it looks like a LOT of it would have to go.
So i went back to the drawing board last night. Made this bezel to fit a standard 7" LCD. Just a test piece so far, need to see how it looks in the car.
There's also a bunch of wire bundles right under it, i'm not sure of those would hit also at this point. Oh, and that SRS module is also very close.
#263
Fits pretty well for a first attempt! maybe a few tweaks.
This also leaves me with enough room to keep the regular single din behind for audio > connect Pi into that.
This also leaves me with enough room to keep the regular single din behind for audio > connect Pi into that.
Last edited by TheBasedDoge; 08-29-2023 at 01:23 PM.
The following users liked this post:
spider2k (08-30-2023)
#264
the other screen with the door looks better but this is definitely a close second. nice work on the modeling.
The following users liked this post:
TheBasedDoge (08-30-2023)
#266
The following users liked this post:
TheBasedDoge (08-30-2023)
#268
i removed the display motherboard, almost fit i need more 5mm to get it perfect.
ps://www.youtube.com/shorts/-ymJRM9ojmk
htthttps://youtube.com/shorts/KarvjzrWBoQ
ps://www.youtube.com/shorts/-ymJRM9ojmk
htthttps://youtube.com/shorts/KarvjzrWBoQ
Last edited by Jdm-UAE; 08-30-2023 at 10:10 AM.
#270