thats pretty fricken sweet. haha what are the chances i work at ultimate electronice in minnesota, i never even thought they could do dash stuff like that haha.

 

bump

 

my contribution to this thread.

current:


before:

 

I think I liked your older setup better...

 

^

Unless the edges were pulling up and it isn't shown in the pic, you should've left it "thinner."

 

 

How is everyones hole holding up? In terms of the pull of the vinyl, etc around the mold? Mine looks pretty good..I notice a tiny sagging of the frame..I think I can get behind it and tighten the sucker!

 

Nothing on my end yet.....But then again I'm what, almost a year behind you on install date?

 

6/26/01 I joined the dash club

 

personally i liked the thinner look myself. however the edges were starting to tear just a little bit so we had to do some slight cutting and the result was we needed a lip around the outside. Next version of the frame is going to be a little better with a raised bevel and smaller lip.