Greddy emanage help
#1
Registered User
Thread Starter
Join Date: Jun 2007
Posts: 2,491
Likes: 0
Received 0 Likes
on
0 Posts
Greddy emanage help
Gday,
Ive been playing around with my base map to engage vtec at 5800rpms, when I upload the map it uploads but when im driving vtec isnt engaging at all, while driving around with the laptop connected too the ecu the highlighted box isnt moving around when im on/off the gas, it stays along the first line..
It did work while I was driving but after I had driven too the petrol station and stopped the car to upload the old map when suddenly it picked up the revs and then vtec was working at my chosen rev range I wanted but then I did something and its not engaging again.
If anyone could help me out much appreciated.
Ive been playing around with my base map to engage vtec at 5800rpms, when I upload the map it uploads but when im driving vtec isnt engaging at all, while driving around with the laptop connected too the ecu the highlighted box isnt moving around when im on/off the gas, it stays along the first line..
It did work while I was driving but after I had driven too the petrol station and stopped the car to upload the old map when suddenly it picked up the revs and then vtec was working at my chosen rev range I wanted but then I did something and its not engaging again.
If anyone could help me out much appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
KFC-AWD
S2000 Engine Management
1
10-11-2016 02:32 PM