s2000 ecu pins and connectors
#11
Thread Starter
in all honesty I would just call someone that deals with flashpro and get a single pin or a few.
it took me hours to figure out what pins go in the 00-05 cars and I had ordered 2 pins that were not correct.
and Thanks Pastoli
if you end up ordering the ecu side connector post in here if it is the right one or not.
I did not order one as I dont need it but everything is telling me it is
it took me hours to figure out what pins go in the 00-05 cars and I had ordered 2 pins that were not correct.
and Thanks Pastoli
if you end up ordering the ecu side connector post in here if it is the right one or not.
I did not order one as I dont need it but everything is telling me it is
#12
Community Organizer
I need to figure out what wire to use to make this jumper harness. Can you shed any insight on what you used? I also need to get some shielded cable wire.
#13
Thread Starter
if I were to do it I would use anything from this page
http://www.prowireusa.com/products.asp?dept=75
this place is also good for stuff
http://www.aircraftspruce.com/menus/el/wire.html
if you have questions just call prowire they have been very helpful for me in the past and I buy all my deustch connectors from them.
as for wire size I am almost positive 22 gauge is fine
prowire.com and onlinecomponents.com have very similar pricing but prowire is just motorsport related so its easier sometimes to navigate their site
http://www.prowireusa.com/products.asp?dept=75
this place is also good for stuff
http://www.aircraftspruce.com/menus/el/wire.html
if you have questions just call prowire they have been very helpful for me in the past and I buy all my deustch connectors from them.
as for wire size I am almost positive 22 gauge is fine
prowire.com and onlinecomponents.com have very similar pricing but prowire is just motorsport related so its easier sometimes to navigate their site
#14
For future reference, I found out about 06+ ecu pins. I called hondata and all they could tell me was that they think the 06+ pins are the same as the rsx. That being said, I have a buddy who is a tech at Acura so I swung by the dealership. All dealerships have a re-pining kit for the shop to use. We went through the kit and I found the correct pins, which have a smaller opening at the end where the male pin is inserted than the 00-05. I grabbed a few so if anyone is in dyer need of some let me know..
#19
Community Organizer
I was reading another thread and came across these links.... Cheers.
http://www.easternbeaver.com/Main/El...SMHW/smhw.html
http://www.newark.com/tyco-electroni...roduct+Catalog (I order from these guys for stuff at work.)
http://www.summitracing.com/parts/AV...00-S/?rtype=10
http://www.easternbeaver.com/Main/El...SMHW/smhw.html
http://www.newark.com/tyco-electroni...roduct+Catalog (I order from these guys for stuff at work.)
http://www.summitracing.com/parts/AV...00-S/?rtype=10