Ok so i am just finishing up my turbo install.

So my turbokit intake pipe to teh TB doesn't have a nipple on there for the crankcase vent tube.

Can I just put a breather filter thingy on there instead? p.s I have krankvents installed also.

 

i have mine open for now, gonna put a filter on it soon hiowever.

 

I was wondering this same thing, I have a clear tube that goes from my intake to my krankcase, I was wondering if I could just put two of those little filters in place of them? There is a little bit of Oil blowby in the clear tube, maybe it is better to leave it so see how much oil I am blowing out of my crankcase?

 

Someone needs to settle this once and for all and see what size the tube on the valve cover is. I'm also curious as I am looking at doing this but I don't know what to buy.

 

Breather on the front run the back to a catch can and the catch either to a vacuum supply or vent it to atmosphere.

 

I just got some for the front, I'll check the size when I get home... but it was too thick and can't get a worm clamp around it. but it's on there pretty tight.

 

Thanks Sarek, look forward to hearing the size so I can take this stupid tube off of my intake already!

 

It's 1/2 inch.